How Do You Clean The Filter Of The Bissell Momentum 3910

Momentum Cyclonic

B A G 50 Due east S S V A C U U M

U S E R ' Southward Grand U I D E

3 9 ane 0 S E R I Eastward S

iii Safety Instructions

4 Product View

v-6 Assembly

6-9 Operation

10-16 Maintenance and Care

17 Troubleshooting

18 Consumer Services

19 Replacement Parts

20 Warranty

ug603-2377_3910E_207.indd 1

2/seven/07 iv:03:31 PM

Thanks for ownership a BISSELL vacuum

Nosotros're glad y'all purchased a BISSELL vacuum. Everything nosotros know nigh floor intendance went into the design and construction of this complete, high-tech habitation cleaning system.

Your BISSELL vacuum is well made, and we back it with a limited i yr warranty. We as well stand up behind it with a knowledgeable, defended

Consumer Services department, then, should you e'er accept a problem, you'll receive fast, considerate aid.

My great-gramps invented the floor sweeper in 1876. Today, BISSELL is a global leader in the pattern, manufacture, and service of high quality homecare products like your BISSELL vacuum.

Thank you again, from all of the states at BISSELL.

Mark J. Bissell

President and Principal Executive Officer

two w w w . b i due south s e fifty l . c o m

ug603-2377_3910E_207.indd two

2/7/07 4:03:33 PM

IMPORTANT Safety INSTRUCTIONS

When using an electrical appliance, basic precautions should be observed, including the following:

READ ALL INSTRUCTIONS BEFORE USING YOUR UPRIGHT VACUUM.

Alert: To reduce

the risk of burn down, electric daze, or injury:

■ Utilise indoors just.

■ Exercise non leave auto when information technology is plugged in.

■ Do not use with damaged cord or plug.

■ If appliance is not working every bit it should, has been dropped, damaged, left outdoors, or dropped into water, return information technology to a service amanuensis.

■ Do not handle unit with wet hands.

■ Do not pull or carry past string, apply cord as a handle, close door on cord, pull string around sharp corners or edges, run apparatus over string, or expose cord to heated surfaces.

■ Do not unplug by pulling on cord. Unplug by grasping plug.

■ Do not run appliance over cord.

■ Exercise not handle plug or appliance with wet hands.

■ Do not betrayal pilus, loose wearable, fingers or body parts to openings or moving parts.

■ Do not selection upwardly hot or burning objects such as cigarettes, matches, or hot ashes.

■ Do non pick up flammable or combustible materials (lighter fluid, petrol, kerosene, etc.) or employ in the presence of explosive liquids or vapour.

■ Do non use appliance in an enclosed space filled with vapours given off by oil base of operations paint, pigment

thinner, some moth proofing substances, combustible grit, or other explosive or toxic vapours.

■ Not intended for use past young children or infirm persons without supervision.

■ Young children should be supervised to ensure that they practise non play with the appliance.

■ Remove plug from electric outlet before cleaning or maintaining the apparatus.

■ If the supply string is damaged, it must be replaced by the manufacturer or its service agent in lodge to avoid a hazard.

■ Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, petrol, etc.).

■ Practice not permit to be used every bit a toy.

■ Do not use for any purpose other than described in this User's Guide.

■ Use just manufacturer's recommended attachments.

■ Do not use with whatsoever opening blocked; keep free of dust, lint, hair, and anything that may reduce air catamenia.

■ Proceed apparatus on a level surface.

■ Plow off all controls before unplugging.

■ Be extra careful when cleaning stairs.

■ This appliance is provided with double insulation. Use only identical replacement parts.

■ Do not use without debris tank and/or filters in place.

■ Pay close attention when working around children.

Relieve THESE INSTRUCTIONS.

THIS MODEL IS FOR HOUSEHOLD USE Just.

IMPORTANT

FOR OPERATION ON A 220-240 VOLT A.C. l/60 Hz Ability SUPPLY ONLY.

FOR RESIDENTS OF THE

UNITED KINGDOM ONLY

If your apparatus is fitted with a nonrewireable BS 1363 plug it must non be used unless a xiii amp (ASTA approved to BS 1362) fuse is fitted in the carrier independent in the plug. (Spares may be obtained from your BISSELL supplier). If for any reason the plug is cut off, it must be disposed of, as it is an electric shock take a chance should it be inserted into a 13 amp socket.

westward w w . b i s s e 50 50 . c o thousand	3
ug603-2377_3910E_207.indd 3	2/7/07 iv:03:33 PM

Bissell 3910 Manual

Product view

Handle

TurboBrush™

Power Switch

Upper Tank

Piece of cake Empty™

Clay Container

Washable

Pre-Motor Filter

Headlight

Foot

Window

Hose and Cord Clip

	Dusting Castor/
	Upholstery Tool
	Power String
Behave Handle	Stretch Hose

Crevice Tool

Extension Wand

Make clean Filter Indicator

(Select Models Only)

HEPA Media

Post Motor Filter

Lock 'northward Seal™ Lever

Handle Release

Pedal

Height Adjustment

Knob

Scuff Resistant Bumper

Wide Cleaning Human foot

4 westward west due west . b i s south due east l fifty . c o thousand

ug603-2377_3910E_207.indd 4

Quick Release™

String Wrap

Twist 'n

Snap™

Hose

Curved

Hose

Wand

Lower

Hose Clip

Hose

Wand

Base of operations

2/7/07 4:03:34 PM

Assembling your vacuum

The only tool you'll need to assemble your vacuum cleaner is a Phillips screwdriver.

Adhere handle to vacuum

Caution:

Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.

1.	Locate the handle and cord wrap. Remove
	the screw packet taped to the string wrap.	2.
two.	Stand the vacuum upright and from the
	rear of the unit, slide the base of the handle
	firmly into the grooves at the peak of the
	vacuum body.
3.	IMPORTANT – before inserting the screws
	into the handle, slide the cord wrap into the
	handle.
four.	Ensure that the handle and cord wrap are
	firmly fit to the vacuum torso. If there are	three.
	whatsoever gaps, continue to push firmly until the
	handle and cord wrap are flush.
v.	Insert 2 of the screws provided (three total)
	into the existing holes, attaching the cord
	wrap and handle to the torso of the vacuum.
	Tighten securely with a screwdriver.
6.	Attach the hose and cord prune past snapping	half dozen.
	information technology into the handle of the unit of measurement. Secure it by
	inserting the spiral provided.

7. Attach the lower hose prune past snapping information technology into place and twisting to the right.

vii.

Hose Clip

Alarm:

Plastic picture show tin can be dangerous. To avoid danger of suffocation, go on away from babies and children.

w west w . b i s south east 50 l . c o m	5
ug603-2377_3910E_207.indd v	2/seven/07 4:03:39 PM

Assembling your vacuum

Attach vacuum hose and tools

one. Line upwardly the tabs on the base of the Twist 'n Snap hose with the corresponding notches on the hose collar as shown.

2. Turn the Twist 'due north Snap hose to the left to lock the hose into identify.

3. Connect the curved hose wand to the hose. Grasping the curved hose wand, slide the end of the curved hose wand onto the hose wand base. Snap the hose into the hose clip.

NOTE: The vacuum volition not operate finer unless the curved hose wand is firmly attached.

4. Slide the extension wand and crevice tool together into the storage clip every bit shown.

5. Slide the dusting brush/upholstery tool into the storage clip as shown.

6. Adhere the TurboBrush by snapping information technology onto the acme cap of the upper tank.

one.

Twist 'northward Snap Hose

Caution:

Before using your vacuum, brand sure that the dirt container is in the locked position and that all filters (pre-motor and HEPA postmotor) are in place. Practice not operate your vacuum without these filters.

Operation

Power switch

The power switch is located just below the handle on the front of the vacuum. Push the rocker switch "ON" (I) to vacuum, and "OFF" (O) when cleaning is complete.

6 w w westward . b i south s e l l . c o 1000

NOTICE:

For higher up flooring cleaning, the floor brush continues to rotate merely is raised above floor. To prevent carpet harm, do not lean on the vacuum or allow the powerfoot tilt forward.

Circumspection: